Bits handy on the electric screwdriver
Screws of various sizes? No problem - The right bit is right here
Online since: 16/12/2010,
Number of visits: 326064
0
General problem: It often happens that you have to screw in screws of various sizes one after the other.
The suitable bit always happens to be far away in some box.
Then it goes again: "Mom, where is the blue box with the...?"
Solution #1:
You can search in your pants pocket between coins, gum, screws and keys for the right bit.
Solution #2:
You have 15 electric screwdrivers with different bits dangling from your work jacket.
Solution #3:
You find a planet on which all screws require the same bit size and order from there.
Solution #4:
You look for an office job.
My solution:
Thread a small white cable tie
through a countersunk pot magnet CSN-25
and a loop that is already part of many electric screwdrivers.
Tighten - cut off the end - done! Time investment: 10 seconds!
Note from the supermagnete team:
- We also offer ready-to-use magnetic helpers in the group Workshop. Some of them are linked below.
- You could also attach the appropriate screws along with the right bits to this countersunk pot magnet.
- A similar application is the project Screws supply readily available, which could also be realized with bits.
The entire content of this site is protected by copyright.
Copying the content or using it elsewhere is not permitted without explicit approval.
Copying the content or using it elsewhere is not permitted without explicit approval.